Drolet Deco II Wood Stove DB03205

Drolet Deco II Wood Stove DB03205

Product Description

Sleek version of the traditional wood stove, the Deco II can heat up to 1,800 ft² with 65,000 BTU/h of maximum power. EPA 2020 certified at 1.26 g/h, this non-catalytic wood stove stands out with its modern design, its higher-than-average height and its storage space under the appliance.

Included: pedestal with ash drawer, top air deflector, ceramic glass, ash lip, air damper

• Up to 6 hours burn time
• Up to 18” logs
• 1.9 ft³ firebox
• Heavy duty 5/16” steel top
• EPA certified
• Proudly made in Canada
• Limited lifetime warranty
• Certified for mobile home and alcove installation
• Weight : 321 lbs

Specifications

Clearance To Combustibles

The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner’s manual, catalogues, flyers, magazines and/or web sites).

Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.

The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner’s manual, catalogues, flyers, magazines and/or web sites).
**Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.

• Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.
• Optimum overall efficiency at a specific burn rate (LHV).
• This appliance is officially tested and certified by an independent agency.
• The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³. Other performances are based on a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.
• As measured per CSA B415.1-10 stack loss method.
• Higher Heating Value of the fuel.
• Lower Heating Value of the fuel.
• The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the solid fuels into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.
• Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.

Product Documents

Wood stove manual | Safety notifications & general information

Installation & Operation Requirements

Dimensions